Our
specialty, the perfect solution for adding air-conditioning and/or
heating to historic homes and buildings, where ductwork is not practical,
or impossible. The 2" inside diameter pre-insulated mini-ducts
that run to each outlet(which can be ceiling, wall, or floor mounted)
can be routed anywhere with ease, even through walls. Increasingly
popular for installation in new construction and condo re-models to
gain more ceiling height. SpacePak systems offer uniform temperatures,
draft-free comfort, 30% greater humidity reduction, easy installation
and super quiet operation. Choose between cooling only, heat pumps,
auxiliary/primary electric heat, auxiliary/primary hot water heat,
chilled water cooling, hot water heating. Chilled/hot water SpacePak
systems can even be zoned using solenoid valves creating ultimate
comfort and energy savings when using multiple air handlers. DX standard
SpacePak systems can also be zoned in the plenum section using dampers
allowing one air handler to individually control temperatures in distinct
areas. Be sure to see the link below regarding zoning.
Also
available are: 13-18 SEER Air Conditioners
- 13-17 SEER Heat-Pumps -
Boilers - Water
Chillers
As
the Series E sells out of inventory, it will be replaced with
the series F below.
The ESP-E series is a horizontal cooling/heat-pump fan coil unit
with a DX (direct expansion / R-22) coil. Puron (R410a units are
available). This SpacePak unit can be matched with a cooling only
condensing unit, or a heat pump unit. For additional heating options
with this unit, an electric duct heater or a hot water coil can
be added. Electric duct heater must be installed horizontally.
This unit can also convert to a vertical discharge, but must still
lay horizontal. Line set 3/8x7/8. MEA approval: MEA-119-85-E.
For more information, email us, or call sales at (813) 977-5286.
